FLEXI FREE OF CHARGEFLEXI

Flexi Free Of ChargeFlexi

Flexi Design is a design-only product. This subscription product offers the same feature set as the top-of- the-line FlexiSIGN & PRINT traditional license product. When you buy a chassis few ports are enabled for free of chargeFlexi provides a full suite of design and production tools for both vinyl cutting and printing. Job search for open vacancies has never been easier.Flexi license allows you to select the port of your choice.

Application Form for Flexi Expatriate Employees PDF (1.20 MB).By deactivating the enabled port, you can activate other ports of yourFlexi Licensing is applicable for 10G ports only.This license upgrade will not disturb the existing port state.This document describes about flexi license on Cisco ASR 920 Series Routers beginning with Cisco IOS XE 3.18.0S Form PDF (1.40 MB)27-07-2021Employment Office License Application Form PDF (1.33 MB. With this license in place, you can choose the ports of your choice to activate additional.

(By default Te0/0/10 & Te0/0/11 operates as 1G mode if 10 G license is not in use) and the remaining 4 portsAny 12 ports 0вЂ“15 and the remaining ports are enabled in 1G mode.SFP+ Ports (24вЂ“27) are enabled based on license count available:License count 1: Any two ports are enabled.Any 12 ports and the remaining ports are enabled in 1G mode.Any of the four ports 0вЂ“15 is enabled as 1G port. By default Te0/0/12 & Te0/0/13 operates as 1G modeAny 6 ports. Warning: SFP+ inserted at port X tengig license not in useCan now choose the ports of your choice to activate 6, 12, or 4 ports on theThe following table displays the details of the licensed and nonlicensed ports on different models of Cisco ASR 920 series.All 6 ports operate in 1G mode by default and no license is required to activate these ports.4 SFP + operates in 10G mode depending on the license count.License count 1: Any 2 SFP+ operates in 10G mode.License count 2: All 4 SFP+ (ports 2вЂ“5) operates in 10G mode.Any 6 ports and remaining 6 port s are enabled after purchasing license. The interface will be in 'link down state'And the following system warning message will be generated. Flexi license restrictions for dual rate portsIf 10G license is installed for a dual rate port and SFP is inserted in that port, the interface will come up in 1G mode.If 10G license is installed for a dual rate port and SFP+ is inserted in that port, the interface will come up in 10G mode.If 10G license is not installed for particular port and SFP is inserted, the interface will come up in 1G mode.If there is a 10G license and SFP+ is inserted in the chassis(for the ports Te0/0/12-Te0/0/15), Te0/0/12вЂ“Te0/0/15 will comeIf sufficient 10G licenses or Bulk Licenses are not available for a port and an SFP+ is inserted, the 10G mode is not enabled. For information onSoftware Activation Feature.

Flexi License